Please login or register.

KRCM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - faskend

Pages: [1]
1
This plane has been only flown a half dozen times and has had no crashes or hard landings. Just not my type of airplane. It comes complete with 9 servos, retracts, brushless motor and 65 amp speed control. I also have a new spare spinner and propeller for it. Just add a receiver and 4s,3000 lipoly to get it in the air. Great Planes price is $410 plus taxes plus $30 for the spare prop and spinner. I am asking $275.

2
Buy, Sell, Trade or Give Away / Hangar 9 Piper Pawnee
« on: May 20, 2018, 08:38:29 PM »
I have a Hangar 9 Pier Pawnee for sale complete with 6 servos, custom pilot and Scorpion 4020-12 brushless motor. The landing gear plywood mount was damaged on a hard landing and has been replaced with a much stronger heavy duty plywood mount. You can't see that it has been repaired. This model has been recently discontinued by Hangar 9 but was sold by Great Hobbies for $430 plus taxes and shipping. I am asking $300 for everything which is less than half what it would cost including the motor and servos. . The cowl has been cutout for a 4 stroke engine but looks fine as is with the electric motor.

3
Buy, Sell, Trade or Give Away / Graupner MZ-24 Pro Radio System
« on: April 22, 2018, 11:13:22 AM »
I bought a Graupner MZ-24 Pro radio on an impulse and have decided that I will stick with what I have as the cost to replace more that 15 receivers and telemetry accessories really doesn't make sense. This radio is brand new and comes with 4 receivers and a carry case.
Asking $495 which would save you over $225 purchased in Canada.
Email  faskend@kos.net

4
Buy, Sell, Trade or Give Away / Custom Copy of the QRX 350 Drone
« on: February 08, 2018, 09:31:50 PM »
I bought this and then decided I really am not interested in Quad copters. This is a complete custom quad copter complete with DJI controller, GPS, G-3d camera mount, and 2 new 3cell 5200ma lipoly batteries. Also included is a complete set of spare parts which alone would cost almost as much as I am asking. All that is needed is am S bus receiver or any 4 channel receiver to get it in the air. I have tested it very basically and proved that the return to home works great. Brought it back to within 3 feet of where it took off.

Asking $325.00

5
Buy, Sell, Trade or Give Away / Custom DJI 350 Quadcopter
« on: November 06, 2017, 10:08:01 AM »
I bought this and then decided I really am not interested in Quad copters. This is a complete custom quad copter complete with DJI controller, GPS, G-3d camera mount, and 2 new 3cell 5200ma lipoly batteries. Also included is a complete set of spare parts which alone would cost almost as much as I am asking. All that is needed is am S bus receiver (I think) to match up to the DJI controller.

Asking $275

6
I have made changes to the write up to try and standardize with the numbering of the control pin configurations. If you plan on doing the modifications yourself be sure that yo don't get confused between the writeu ps. I will have the first revision removed from the forum.

7
General Discussion / Lithium Polymer Battery Safety and Maintenance
« on: February 26, 2011, 11:08:24 AM »
See attached file

Pages: [1]